Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Adjustments
5
Adjustments
5.1
Adjustment of the gripping range
Before the product can be lifted and transported, the gripping range has to be adjusted to the
dimensions of the product.
Otherwise it is not guaranteed, that the clamping force is high enough to grip the gripping
good safely. → Consequence: gripping good could slide down!
•
The adjustment of the gripping range may never take place on both sides at the same time.
Always adjust the gripping range first to the one and then on the other side.
•
Lift the unit approx. 0.5 m. Gripping arms must be locked and open (automatic release
position "empty").
•
Pull the spring bolt
•
Move the rectangular tube
•
Pull the spring bolt
•
Move the rectangular tube
The adjustment of the gripping range must follow general symmetrical.
That means, it must be used in each case the same adjustable hole with both rectangular tubes
To ensure that the device is in a horizontal position when lifting the gripped goods.
Otherwise there is a risk of sliding and damage!
Caution while adjusting of the gripping range. There is a danger of injuring the
hands! Use safety gloves.
53100256
upwards, rotate around 180° and lock in position (in nick).
, until the gripping range is approx. 5 cm larger than the product.
upwards again and rotate around 180°.
so long until the spring bolt
13 / 23
engages in one of the holes.
in
.
GB
Advertenties
Hoofdstukken
Inhoudsopgave
