Download Inhoudsopgave Inhoud Print deze pagina

Fixing The Product; Connect The Plug With The Socket Of The Spotlight - Parkside PLAL 1 A1 Bedienings- En Veiligheidsinstructies

Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

Prior to installation, verify that the mains
voltage on site corresponds with the
operating voltage required for the product
(230 V∼, 50 Hz) . Otherwise do not install the
product .
CAUTION! DANGER OF BURN
INJURIES! To prevent burns, verify the
product is switched off and has cooled down
for at least 15 minutes before touching it . The
product can become very hot .
The accessible surface, especially heat shrink,
is very hot when the lamp is operating .
FIRE HAZARD! Fit the product
m
so that it is at least 1 m away from
the material to be illuminated .
Excessive heat can result in a fire .
The product is only suited for use with the
built-in LED control gear .
The product continues to draw a small
amount of power even if the product is off as
long as the product is connected to the supply
mains . To switch the product off completely,
disconnect the plug 4 from the socket .
The plug can only be connected with a
corresponding socket with the same IP in
order to keep the protective degree against
dust/water . For HG05476-BS, plug for
indoor use only .
˜ Before installation
NOTE: Remove all packaging materials from
the product .
Place the spotlight 1 on a stable substrate .
Check the stability of the spotlight 1 .
8
GB/IE/NI
˜ Fixing the product
Fold out the hook 2 to suspend the product from
a suitable suspension point .
˜ Use
Plug the plug 4 into the socket .
Push the switch 3 to the I position to turn on
the product .
NOTES:
Insert the plug to the corresponding
IPX4 socket only during outdoor use .
Or the plug should be for indoor use if no
corresponding IPX4 socket can be found .
˜ Connect the plug with the
socket of the spotlight
Open the socket cover 5 behind the
product .
Connect an additional item by plugging it into
the socket of the spotlight 6 (see fig .) .
Close the socket cover 5
(for HG05476-BS) .
For HG05476-BS, lock with the interlock 7 .
NOTE: Make sure the connected item is
equipped with water proof plug .
m WARNING! Do not connect any appliance
with a total output of > 2500 W . Otherwise
there is the risk of a fire .
For HG05476/HG05476‑FR:
The socket of the spotlight is only
IPX4 protected .
Insert only corresponding IPX4 plug for
outdoor use .

Advertenties

Inhoudsopgave
loading

Inhoudsopgave