Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Identify the supply pipe and follow this procedure:
Insert the seal washers into the two threaded nuts of the water supply pipe;
Screw on a threaded nut at the solenoid valve outlet located at the rear of the appliance without
overtightening to prevent the risk of breakage of the joints;
Tighten the other threaded nut on the water supply stopcock.
DRAINS CONNECTION
To connect the discharge pipe ensure that it is connected in an open trap.
Connect the waste pipe onto the elbow located underneath the machine by applying moderate manual
pressure. The above 2m waste pipe is also supplied with the machine.
DETERGENT DISPENSER CONNECTION (Optional)
When required, the machine can be supplied with built in electric detergent dispenser.
In the event of the doser being required after machine purchase, only have this installed by "professional
personnel" or "technical staff of the nearest after-sales centre".
Doser installation requires:
Electrical connection: connect the power wires of the detergent dispenser in parallel with the power
wires of the machine control solenoid valve.
Water connection: Cut the supplied tube in two parts. Fit the filter and the weight in one end of the
suction tube and connect the other end to the inlet connection of the detergent pump. Fit the detergent
injector in the hole in the tank. Connect the second tube between the outlet connection of the
detergent pump and the injector. Put the tube with the filter and the weight into the detergent bin.
WATER SOFTENER CONNECTION (Optional)
To ensure the long life of your machine, only use "soft water" for washing. Get to know the hardness of your
water supply (contact your town council or drinking water utility).
It is important that an 8 or 12 L water softener, for glasswashers, and 16 or 20 L water softener, for dishwashers
is installed with the machine to achieve maximum washing power, (contact the Service Department).
BOOSTER PUMP (Optional) (Fig. 1)
In the event of the water supply pressure being below 0.2 MPa (2 bar), it is best to fit an auxiliary pump to
increase the pressure. At the time of ordering, depending on the model, the machine can be supplied complete
with a booster pump. Should the dishwasher not be used for long periods, check that the rinse booster pump
turns freely. This is done by turning a screwdriver in the appropriate slot in the motor shaft (fan side). Should it
be jammed, hit the end of the screwdriver lightly with a plastic hammer.
Fig. 1
Advertenties
Inhoudsopgave
Probleemoplossen
