CAUTION!
If there are other appliances installed in
the same cabinet, do not use them at the
same time as this function. It can cause
damage to the oven.
Do not start the function if you did not fully
close the oven door.
1. Make sure that the appliance is cold.
2. Remove all accessories and removable
shelf supports.
3. Clean the oven interior and the inner door
glass with warm water, a soft cloth and a
mild detergent.
4. Turn the knob for the heating functions to
to enter Menu.
5. Turn the control knob to select
press
.
Cleaning programme
C1 - Light cleaning
C2 - Normal cleaning
C3 - Thorough cleaning
6. Turn the control knob to select the
cleaning programme and press
7. Press
to start cleaning.
When the cleaning starts, the appliance door
is locked and the lamp is off. Until the door
unlocks the display shows
8. After cleaning, turn the knob for the
heating functions to the off position.
9. Wait until the appliance is cold and the
door unlocks. Clean the oven interior with
soft cloth and water.
11.5 Cleaning Reminder
When
flashes on the display after cooking
session, the appliance reminds you to clean it
with pyrolytic cleaning. You can turn off the
reminder in the submenu: Settings. Refer to
"Daily use" chapter, Changing: Settings.
42
ENGLISH
11.6 Removing and installing the
door
You can remove the door and the internal
glass panels to clean it. The number of glass
panels is different for different models.
1. Make sure the appliance is cold
2. Fully open the door.
3. Press the clamping levers
and
Duration
1 h
1 h 30 min
3 h
4. Close the oven door to the first opening
.
5. Hold the door with one hand on each side
6. Put the door with the outer side down on
.
7. Hold the door trim
8. Pull the door trim to the front to remove it.
9. Hold the door glass panels on their top
WARNING!
The door is heavy.
CAUTION!
Carefully handle the glass, especially
around the edges of the front panel. The
glass can break.
door hinges.
A
position (at approximate angle: 70°).
and pull it away from the oven at an
upwards angle.
a soft cloth on a stable surface.
the door at the two sides and push
inwards to release the clip seal.
2
B
edge one by one and pull them up out of
the guide.
on the two
A
on the top edge of
1