Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ASSEMBLY STEP 3
HARDWARE FOR STEP 3
PART
TYPE
DESCRIPTION
A
BOLT
M8X1.25PX20L
B
SPRING WASHER
8.2X15.4X2T
C
FLAT WASHER
8.4X15.5X6T
RUNNING
DECK
CONSOLE CABLE
14
A
Open HARDWARE FOR STEP 3.
QTY
B
Attach LEAD WIRE to bottom end of CONSOLE
4
CABLE. Pull LEAD WIRE through RIGHT CONSOLE
4
MAST (1). After pulling the lead wire through the
4
mast, the top of the CONSOLE CABLE should be
located at the top of the mast.
C
With the RUNNING DECK in the raised position,
attach the RIGHT CONSOLE MAST (1) to the BASE
FRAME (2) using 4 BOLTS (A), 4 SPRING WASHERS
(B) and 4 FLAT WASHERS (C).
NOTE: Do not tighten bolts completely
until after the console is assembled.
A
B
C
ASSEMBLY STEP 4
HARDWARE FOR STEP 4
PART
TYPE
DESCRIPTION
A
HEX SOCKET BOLT
M6X1.0PX15L
A
1
A
A
3
2
A
Open HARDWARE FOR STEP 4.
QTY
B
Attach LEFT SIDE of the CROSSBAR (1)
4
to the UPRIGHT MAST (2) loosely using
2 BOLTS. (A)
C
Attach RIGHT SIDE of the CROSSBAR (1)
to the UPRIGHT MAST (3) loosely using
2 BOLTS. (A)
NOTE: Do not tighten bolts completely
until after the console is assembled.
15
Advertenties
Inhoudsopgave
