Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
CHARGING A MOBILE PHONE
The USB socket on the left side can provide DC power of 5V/1A for charging a mobile
phone. Connect the mobile phone to the USB socket with an appropriate cable (not
included with this radio). The USB power is available in all modes, including standby
mode.
Refer to the user manual or the manufacturer of the mobile phone to verify if it supports
charging from an USB power.
Warning: Never use the USB socket in rainy or moist conditions to prevent moist from
entering the radio and so to prevent potential short circuit. Always keep the rubber cover
well closed under these conditions.
It is recommended to use AC power while charging a mobile phone via USB socket. On
DC power it is also possible to charge a mobile phone from the USB socket, however
using DC power to charge a mobile phone will consume energy from the batteries and
so drain the batteries easily.
AUX IN MODE
A 3.5mm stereo Aux-In socket is provided on the side behind the rubber cover, for
connecting an external audio device such as MP3 player or CD player (Aux cable not
included with this radio).
1.
Connect an external player to the Aux-In socket.
2.
Press the Source button to select AUX input. Display will show "AUX IN".
3.
Play the external player.
4.
Adjust the volume both the radio and the player for comfortable listening.
5.
After use, close the rubber cover to prevent moist or dust from entering into the
sockets and radio.
Notes: Never use the Aux-In socket in rainy or moist conditions to prevent moist from
entering the radio. Keep the rubber cover well closed under these conditions.
The Auto-Power management function will be activated in AUX IN mode. If there is no
signal* from the Aux-In socket for a period of over 15 minutes, the Workstation radio will
automatically switch to standby mode. Pressing the On/Off button will wake up the unit.
* Also when the incoming signal from the external device is too low and cannot
be detected for a period of over 15 minutes by the Auto-Power management, the
Workstation radio will switch to standby mode.
To prevent this raise the output level of the external device enough to be detected.
GB
GB
18
Advertenties
Hoofdstukken
Inhoudsopgave
