Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Scan sensitivity setting – FM
The radio will normally scan all stations from FM broadcasts including the weaker
signals. However, you may wish the Auto-scan to find only those stations with strong
enough signals to give good reception.
1.
Press the On/Off button to turn on the radio.
2.
Select the FM band by pressing the Source button.
3.
Press the Menu button, the display shows "Scan setting".
4.
Press the Tuning knob.
5.
Rotate the Tuning knob to select between "All stations" or "Strong station" (default
is "All stations"). The "Strong station" option will allow the radio to find strong signals
only when scanning.
6.
Press the Tuning knob to confirm your setting. The display will return to normal
radio display.
PRESET STATIONS
Storing preset stations
There are 20 memory presets in the radio, 10 for DAB and 10 for FM. Presets are
remembered by the radio in the event of a power failure.
1.
Press the On/Off button to turn on the radio.
2.
Press the Source button to select the desired waveband.
3.
Tune to the required station.
4.
Press and hold the required Preset button until the radio beeps and shows "Stored".
5.
Repeat step 3 and 4 for the remaining presets.
6.
Stations stored in the preset memories can be over-written by following the above
procedure.
Recalling preset stations
1.
Press the On/Off button to turn on the radio.
2.
Press the Source button to select the desired waveband.
3. Briefly Press the required Preset button. In FM mode the display will show for
example "P1" on top right hand side.
13
Advertenties
Hoofdstukken
Inhoudsopgave
