Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
5. Installation electrical
Make sure that you never exchange
the Positive (+) and Negative (-) of
the electricity supply!
Make sure that all cables are installed properly,
solidly and without any friction.
Carefully seal the hole with suitable sealing mate-
rial, from the inside and the outside.
E5
Basic station
Fix the housing lid of the Basic Station.
Mount the antenna cable in accordance with the
notes on the Basic Station. If the radio signal
reception
is
poor,
antenna to 54 cm The cable should be taken
outside the vehicle taking care that the aerial
does not come into contact with any metal parts.
E6
Connection D-Plus (Safety circuit,
optional)
If the D+ signal from the vehicle has been con-
nected to the contact and a signal is present, the
MoveControl unit may not be put into operation.
Such a safety switching circuit may inhibit the
designated use.
If this function shall be used, an additional ground
connection (GND) to the towing vehicle will be
required apart from the D+ signal connection.
E7
Connection battery
Now connect the 16 mm² cables to the
battery. The electrical installation is now com-
pleted.
then
you
extend
the
GB7
Advertenties
Hoofdstukken
Inhoudsopgave
