2. Security advices
It is important that you read this manual care-
fully before installing and operation the RK
Mover. Please keep it handy in your vehicle!
The person who installs the MoveControl is re-
sponsible for the faultless and proper installation.
We recommended that you to have the MoveCon-
trol installed by skilled staff from a specialized
workshop. The MoveControl can be installed in
front of or behind the axle.
Parts of the chassis, axle, suspension or the
brake mechanism must never be removed,
changed or affected. A perfect operation is only
guaranteed if the MoveControl is correctly in-
stalled, if the tyre pressure is correct and if the
drive rollers are in the correct distance from the
tyres.
Reich GmbH assumes no liability for any kind of
damage that might occur to a caravan or trailer
because of the installation or the operation of the
MoveControl.
In case of any damage due to a failure of the
MoveControl, caused by a production fault, we
only compensate for the maximum acquisition
cost of the MoveControl within the guarantee
period.
We reserve the right to change the moving drive
of the MoveControl without notice, at any time.
The MoveControl is meant as a moving aid for
caravans and other trailers, to be used on camp-
ing sites and private grounds.
It is not allowed to sell the MoveControl to the
USA or to Canada, or to use it in those country's.
Reich GmbH reserves all rights. It is not allowed
to duplicate, save or publish, by print, photo copy,
micro film or in any way, neither electronically or
mechanically, this installation and operation man-
ual as well as its content without previous written
consent of Reich GmbH.
BEFORE MOVING, PLEASE CHECK THAT THE
FRICTION ROLLERS ARE ENGAGED ON TO
THE TYRE (Pic. 3.5 = ON).
ONLY IN THIS POSITION THE RANKING
PROCESS IS ALLOWED TO!
BEFORE TOWING THE CARAVAN, PLEASE
GB2
CHECK THAT THE FRICTION ROLLERS ARE
IN THE BACK POSITION (Pic. 3.4 = OFF).
Before you release the fric-
tion rollers, please ensure
that your brake is engaged
to prevent your caravan roll-
ing away!
When installing a caravan-moving
device, in principle, the ground clear-
ance of the caravan is reduced.
When driving or moving, please be
aware
of
the
clearance (80 mm minimum - 120 mm
recommended ground clearance is
required).
If you experience problems do not use the
MoveControl. Please have the device checked
at an authorized dealer.
For all installation and maintenance work you
should turn off the power supply with the isolation
switch.
Ensure that no one turns the main switch on
again and disconnect the battery (first the nega-
tive pole).
Working with the power connected is extremely
dangerous.
Batteries have to be treated, stored or disposed of
in accordance with the manufacturers instruc-
tions. Send old batteries to the recycling process.
Be careful of chemical burns: Battery acid is
strongly corrosive.
Keeping children away from acid and batteries.
A solid seat of the battery has to be respected.
Following notes on the battery and checking
these regularly. Replacing or charging has to be
carried out with great care.
Hint:
Hint:
Hint:
Hint:
We can accept no liability for damages that occur
through non compliance with these instrauctions.
Modifications and errors excempt.
reduced
ground