Inhoudsopgave
Advertenties
– This parameter is entered by pressing the (H) arrows on the control panel.
– This parameter is entered by holding the "
panel. If the user is in the "
will automatically set the value of
The system automatically calculates the distance between the gravity centres of the weights, assuming
that their width is approx. 14 mm.
The machine can be set to automatically start the balancing process after the wheel guard is closed. To
activate this function, press and hold the " " (K) and "
time. This setting is erased after the machine is switched off and on again.
Wheel balancing
1.
Close the wheel guard. Press the "
been set.
2.
The wheel gain speed for a few seconds. After the device has measured the unbalance, the wheel will stop
and the (A) and (B) displays will show the weights needed to balance the tyre.
3.
Lift the wheel cover, then place the appropriate weights on the rim as follows: Turn the wheel slowly with
your hand until one of the indicators, (C) or (D), is fully lit. If the (C) indicator comes on, place the weight
on the inner side of the wheel in the 12 o'clock position. If the (D) indicator comes on, place the
appropriate weight on the outer side of the wheel, also in the 12 o'clock position.
EN
" (J) button and pressing the (H) arrows on the control
" parameter setting mode and holds down the "
= 0.8
.
" (O) button unless the automatic start-up of the machine has
" (J) button, the device
" (M) buttons on the control panel at the same
Advertenties
Inhoudsopgave
