Download Inhoudsopgave Inhoud Print deze pagina

Makita DUS108 Gebruiksaanwijzing pagina 18

Draadloze tuinsproeier
Inhoudsopgave

Advertenties

DRAINING THE TANK
I there s any lqud let n the tank ater sprayng, the tank should be draned beore cleanng.
• Remove the battery pack.
• Dran the contents through the ll area and the lqud outlet.
NOTE: Make sure that the O-ring inside the liquid outlet cap is in place.
NOTE: Dran the lqud back nto the orgnal contaner. Do not store chemcal lqud n the tank.
CLEANING THE TANK
• Fll the tank about one-thrd ull wth clean water. A small amount o mld household detergent may be added.
NOTE: Never use ammable chemcals or abrasve cleanng agents to clean the tank.
• Wipe the outside of the tank with a clean, dry cloth.
• Renstall the battery pack. Spray untl the tank has been empted. Make sure to drect the spray toward an area that
wll not be damaged by the spray soluton.
• Rell and repeat the procedure wth clean water. It may be necessary to rnse the tank more than once, then dran
agan as nstructed above.
• Allow all parts to completely dry beore renstallng parts and storng the unt.
CLEANING THE NOZZLE
I the nozzle becomes plugged, use the steps below to clear.
• Remove the battery pack.
• Loosen and remove the nozzle from spray wand.
• Push a small wre through the exposed holes to clear any debrs. Then ush wth clean water. Reer to Fgure 14.
CLEANING THE PUMP
I the sprayer cannot draw the ud rom tank or t cannot spray out lqud at the rst use or ater long-term storage.
Follow the procedures below to clean the pump:
1. Swtch o the machne and remove the battery.
2. Remove the spray wand from handle.
3. Drain any remaining liquid or store leftover liquid to another container to make sure the tank is empty.
4. Unscrew the red cap to open water inlet hole, and then connect the hole to the water tap. Make sure the O-ring is
placed inside the red cap. Refer to Figure 15.
5. Open the water tap slowly and press down the lever at the same tme to allow water ush away any debrs
adhered to the pump. Refer to Figure 16.
6. Disconnect the water tap and re-tighten the red cap. Make sure that the O-ring inside the cap is in place.
1
2
1 Red cap
Figure 15
Figure 14
2 O-ring
18 English
Figure 16

Advertenties

Inhoudsopgave
loading

Deze handleiding is ook geschikt voor:

Dus158

Inhoudsopgave