Inhoudsopgave
Advertenties
• Before the product is installed,
check the product for any dam-
age after transport. Contact
the importer or the authorized
service centre if damaged.
1.6
Installation Safety
• Before beginning the installa-
tion, de-energize the power line
to which the product will be
connected by turning off the
fuse.
• Always wear protective gloves
during transport and installa-
tion. Otherwise there is a risk
of injury from sharp edges!
• Before the product is installed,
check the product for any dam-
age. Do not have it installed if
the product is damaged.
• Never place the product on a
carpet-covered floor. Product
Otherwise, lack of airflow be-
neath the product will cause
electrical parts to overheat.
This will cause problems with
your product.
• The product should be placed
directly on a clean, flat and
hard surface. It should not be
placed on a plinth or bed plate.
Products must not be placed
on cardboard or plastic plates.
• Direct sunlight and heat
sources, such as electric or
gas heaters, must not be
present in the area where the
product is installed.
• Keep the surroundings of all
ventilation ducts of the
product open.
• Do not install the product near
a window. There is a risk that
the hob flame will ignite cur-
tains and flammable materials
around the hob. When you
open the window, hot cook-
ware may tip over.
• To avoid overheating, product
installation should not be car-
ried out behind decorative cov-
ers.
• In cases where a gas hose/
pipe or plastic water pipe is
situated behind the designated
installation area for the
product, it is imperative to
guarantee that there is no con-
tact between the product and
these utility lines. Otherwise
the hose/pipe may be crushed.
• If there is a socket behind the
place where the product will be
installed, it must be ensured
that the product does not
come into contact with the
socket nor with the plug
plugged into the socket.
EN / 9
EN
NL
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
