Inhoudsopgave
Advertenties
GB
IE
Transport
The carrying handle (5) can be used for
transporting.
Changing the switch-
on and cut-off pressure
(specialists only)
Attention! Before changing the pres-
sure, check whether the connection
cables and the connected end de-
vices can withstand the pressure!
Attention! Danger! Risk of electric
shock at the connection terminals in
the pressure switch when the cover
is removed. Only specialists may
open and configure the pressure
switch!
The pressure switch is configured at the
factory so that most applications are cove-
red. This preconfiguration can be changed
as needed.
The larger screw/nut (I) is
for setting the switch-on
I
pressure and the smaller
one (II) is for setting the
II
pressure difference. The
pressure is changed by
turning them to the left or
right.
• Turning right increases pressure
• Turning left decreases pressure
Make sure the pressure difference is
always 1.5 bar.
22
The switch-off pressure must always be
less than the maximum operating pressure
of the pump and the diaphragm pressure
tank.
After configuring the pump, switch it on
and read the pressure gauge to check
whether the desired cut-off pressure and
switch-on pressure are met. If necessary,
repeat the configuration process above
until you achieve the correct switch-on and
cut-off pressure.
Disposal/environmental
protection
The device, accessories and packaging
should be properly recycled.
Electrical devices must not be dispo-
sed of with domestic waste.
•
Take the device to a recycling plant.
The plastic and metal parts used on
your device can be properly sorted
according to materials and grades and
efficiently recycled. Please contact our
service centre for more information.
•
Dispose of the box in paper recycling.
Dispose of plastic parts in the Dual Sys-
tem.
Advertenties
Hoofdstukken
Inhoudsopgave
