Download Inhoudsopgave Inhoud Print deze pagina

Connecting The Power Supply - Stiebel Eltron SHD 30 S Handleiding Voor Bediening En Installatie

Gesloten warmwater-doorloop
Inhoudsopgave

Advertenties

installation
installation

9.2.5 Connecting the power supply

Danger of electrocution!
Carry out all electrical connection and installation
work in accordance with relevant regulations.
Danger of electrocution!
Connection to the power supply is only possible as a
permanent connection. The appliance must be able
to be separated from the mains power supply by an
isolator that disconnects all poles with at least 3 mm
contact separation.
Risk of damage
!
Observe the type plate. The specified voltage must
match the mains voltage.
Earth connection.
Ensure that the appliance is earthed.
Pull off the temperature selector.
»
Undo the screws.
»
Remove the bottom cap.
»
Pull out the cable grommet at the base while pressing the
»
snap-in tabs.
Push the cable grommet over the power cable and snap the
»
cable grommet back in place.
Connect the power cable to the mains terminal (see chapter
»
"Specification / Wiring diagrams and connections").
WWW.stieBel-eltron.com
7
6
5
1 Pressure switch for protective anode
2 Operating mode switch
3 Thermostat
4 Electronic assembly
5 Contactor
6 Flange plate
7 Seal ring
Select the operating mode using the switch:
»
Position I =Instantaneous DHW cylinder operation
Position II = Dual-circuit/single circuit operation
(see chapter "Specification / Wiring diagrams and connections").
1
2
4
3
sHd s |
21

Advertenties

Inhoudsopgave
loading

Deze handleiding is ook geschikt voor:

Shd 100 s

Inhoudsopgave