Safety; General Safety Instructions; Regulations, Standards And Instructions; Appliance Description - Stiebel Eltron SBB 600 WP SOL Handleiding Voor Bediening En Installatie
Staande warmwater
Verberg thumbnails
Zie ook voor SBB 600 WP SOL:
- Handleiding voor bediening en installatie (96 pagina's)
Inhoudsopgave
Advertenties
INSTALLATION
SAfETY
INSTALLATION
6.
Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
6.1
General safety instructions
We can only guarantee trouble-free function and operational reli-
ability if original spare parts intended for the appliance are used.
6.2
Regulations, standards and instructions
Note
Observe all applicable national and regional regulations
and instructions.
7.
Appliance description
7.1
Standard delivery
Delivered with the appliance:
- Signal anode
- Temperature sensors
- Heat conducting paste
- Thermometer
- Additional type plate
- Label "Signal anode information"
7.2
Accessories
7.2.1 Required accessories
Depending on the static pressure, safety assemblies and pressure
reducing valves are available. These type-tested safety assemblies
protect the appliance against inadmissible excess pressure.
7.2.2 Further accessories
In addition, flanged as well as threaded immersion heaters and
thermal insulation are available as accessories.
If it is not possible to insert a rod anode from above, install a
segmented anode.
WWW.STIEBEL-ELTRON.COM
8.
Preparations
8.1
Installation site
f Always install the appliance in a room free from the risk of
f
frost and near the draw-off point.
f Ensure the floor has sufficient load bearing capacity and
f
evenness (see chapter "Specification / Data table").
f Observe the room height and height when tilted (see chapter
f
"Specification / Data table").
8.2
Transport
For handling/lifting, use the lifting eyes provided, but never the
"Optional DHW outlet" connection at the top of the appliance.
9.
Installation
9.2.1 Fitting the thermal insulation, if appropriate.
f Position the appliance in its intended site.
f
f Fit the thermal insulation according to the instructions sup-
f
plied. For this, ensure that there is enough space for the
installation task. You can then link the appliance into the
heating and DHW system.
9.2.2 Fitting the signal anode
Material losses
!
When operating the cylinder without consumption indica-
tor, leave the plug in the fitting.
f Pull the plug out by simultaneously pushing the pressure
f
ring down.
f Push the open pipe end of the consumption indicator into the
f
aperture for the anode.
SBB 600-1000 WP SOL |
17
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
