TROUBLESHOOTING
General
Troubleshooting table (induction)
SYMPTOM
The fan runs on for several
minutes after the hob has been
switched off.
A slight smell is noticeable the
fi rst few times the hob is used.
You can hear a ticking sound in
your hob.
The pans make a noise while
cooking.
You have switched a cooking
zone on but the display keeps
fl ashing.
Th e service department telephone number can be found on the
guarantee card provided or on 'www.atag.nl'.
If you notice a crack in the glass top (however small), switch the
hob off immediately, unplug the hob, turn off the (automatic) fuse
switch(es) in the meter cupboard or, in the event of a permanent
connection, set the switch in the power supply lead to zero.) Contact
the service department.
If the appliance does not work properly, this does not always mean
that it is defective. Try to deal with the problem yourself fi rst by
checking the points mentioned below or check for more information
the website 'www.atag.nl'.
POSSIBLE CAUSE
The hob is cooling down.
The new appliance is heating
up.
Th is is caused by the capacity
limiter on the front and back
zones. Ticking can also occur at
lower settings.
Th is is caused by the energy
fl owing from the hob to the
saucepan.
Th e pan you are using is not
suitable for induction cooking
or has a diameter of less than
12 cm.
GB 34
Induction
SOLUTION
Normal operation.
This is normal and will disap-
pear once it has been used a
few times. Ventilate the
kitchen.
Normal operation.
Th is is caused by the energy
fl owing from the hob to the
saucepan. Th is is not harmful
for the pans or hob.
Use a suitable pan
(see page 14 and 15).