Advertenties
Mounting and adjusting the squeegee
Mounting and adjusting the squeegee
Proceed as follows to install it:
Proceed as follows to install it:
For perfect drying, the squeegee must be adjusted in such a way that the edge of the rear blade bends during
Moving the machine when not in operation
Proceed as follows to move the machine.
raise the front of the machine by levering on the handle and move it to the destination;
on arrival, lower the front of the machine.
Mounting and changing the brush/drive disks
During brush/drive disk attachment and release, pay attention to brush rotation.
During brush/drive disk attachment and release, pay attention to brush rotation.
Never work without the brushes and drive disks correctly installed.
Never work without the brushes and drive disks correctly installed.
Brush/drive disk attachment:
of the machine by levering on the handle, then lower it onto the brush, centring it with the brush cover. Operate
is not successful, press on the handle again and repeat the centring and repeated operation of the brush lever.
Brush/drive disk release:
After a few pulses, the brush (or drive disk) is released and falls to the ground.
Detergents - Instructions
Always dilute the detergent according to the manufacturer's instructions. Do not use sodium hypochlorite
(bleach) or other oxidants, particularly in strong concentrations. Do not use solvents or hydrocarbons.
The temperature of the water and detergent must not exceed the maximum indicated in the technical
driers.
For a complete and up-to-date list of the detergents and chemical products available, contact one of the manufac-
turer's trained and authorised dealers.
Follow the safety precautions concerning the use of detergents given in the section "IMPORTANT SAFETY PRE-
CAUTIONS".
drive disks
DANGER
DANGER
WARNING
WARNING
WARNING
EN
-
25
Advertenties
