Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
10. Disposal and recycling
The unit is supplied in packaging to prevent its
being damaged in transit. This packaging is raw
material and can therefore be reused or can be
returned to the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local
council. 24
For EU countries only
Never place any electric tools in
your household refuse.
To comply with European Directive 2002/96/EC
concerning old electric andelectronic equipment
and its implementation in national laws, old
electric tools have to be separated from other
waste and disposed of in an environment-friendly
fashion, e.g. by taking to a recycling depot. Re-
cycling alternative to the demand to return elec-
trical devices:
As an alternative to returning the electrical device,
the owner is obliged to cooperate in ensuring that
the device is properly recycled if ownership is
relinquished. This can also be done by handing
over the used device to a returns center, which will
dispose of it in accordance with national commer-
cial and industrial waste management legislation.
This does not apply to the accessories and auxi-
liary equipment without any electrical components
which are included with the used device.
11. Possible causes of failure
Problem / Cause / Solution
P. The compressor does not start
18
OPERATING INSTRUCTIONS
C. No supply voltage
S. Check the supply voltage, the power plug and
C. Insufficient supply voltage
S. Make sure that the extension cable is not
C. Outside temperature is too low
S. Never operate with an outside temperature of
C. Motor is overheated
S. Allow the motor to cool down. If necessary,
P. The compressor starts but there is no
C. Leak in the non-return valve (15)
S. Replace the non-return valve
C. The seals are damaged.
S. Check the seals and have any damaged seals
C. Leak in the drain valve (7)
S. Tighten the screw by hand. Check the seal on
P. The compressor starts, pressure is shown
C. Loose hose connections
S. Check the compressed air hose and tools and
C. Leak in a quick-lock coupling
S. Check the quick-lock coupling and replace if
C. Insufficient pressure set on the pressure
S. Tighten the pressure regulator further or con-
the socket-outlet.
too long. Use an extension cable with large
enough wires.
below +5°C.
remedy the cause of the overheating.
pressure
replaced by a service center
the screw and replace if necessary.
on the pressure gauge, but the tools do not
start.
replace if necessary.
necessary.
regulator.
nect the hose to the coupling for unregulated
tank pressure.
Advertenties
Inhoudsopgave
