Inhoudsopgave
Advertenties
OPERATION
All pre-set programmes can be freely modi-
fied – you can adjust temperature or duration.
To do this, follow the relevant instructions
("Preview and modify settings during oven
operation" and "Timed operation"). When you
make any adjustments, the stored pre-set
programme is not affected and the original
settings will be restored the next time you
select a pre-set programme.
Pre-set programmes with quick pre-heat
Some pre-set programmes require the oven
to be pre-heated. They are marked accor-
dingly in the above table. When you select
a pre-set programme with pre-heating and
touch
to confirm, the quick pre-heat
pictogram will be displayed. When the set
temperature is reached, you will hear bee-
ping, which will turn off when you open the
oven door. Place the food in the oven and
close the door, at which point the actual pre-
set programme will start.
Note: It is inadvisable to modify a pre-set
programme during the quick pre-heat phase
as this will cancel the pre-set programme and
the appliance will operate with the currently
set function, duration and temperature.
End a pre-set programme.
When a pre-set programme ends, you will
hear beeping.
Steam programmes
When the appliance is on, touch
cess the pre-set programmes menu – the
pre-set programme "P01" will be shown on
the display. Use the
select the programme marked as P01S-
P09S.
The oven is equipped with special stainless
steel bowls:
- perforated for vegetables and fish
- solid for meat.
Place the steel bowls with food on the wire
shelf. Close the oven door.
to ac-
and
sensors to
Select a steam programme P01S-P09S and
press OK. The steam
indicators flash on the display. Water
container drawer is located in the front panel.
Push and then pull the container drawer. Pour
0.5 litres of water into the container. Close
the container drawer and touch OK to confirm
and start the programme. The
indicators are displayed, and in addition, the
oven preheating symbol lights up.
IMPORTANT: When the
flashes on the display or you hear a beep
during the cooking programme, you need to
add water. Proceed the same as you added
water for the first time.
NOTE! When water runs out the programme
is not interrupted!
At the end of the programme you will hear
a beep and the
water indicators will flash on the display. You
can touch any sensor to mute the beeping.
Open the door ajar to the first position (about
15°).
You can open the door all the way after a
few seconds.
Then place deep baking tray under the water
drain.
Touch OK to acknowledge the completed
programme.
88
and the Add water
and
add water symbol
steam and
drain the
Advertenties
Inhoudsopgave
