Inhoudsopgave
Advertenties
Operation of the gas detector in the charging cradle in a
vehicle is only permitted under the following conditions:
– Acoustic signalling must be deactivated (with the help of
the PC software CC-Vision) so that the driver is not
distracted.
3.4
Approvals
A copy of the name plate, the declaration of conformity and
the sensor data relevant for measurement purposes are
provided in the enclosed supplementary documentation (part
no. 90 33 655).
Explosion protection:
BVS 17 ATEX E 040 X certifies the intended use in explosion-
hazard areas and the measuring function for explosion
protection. PFG 19 G 001 X certifies the measurement of
oxygen deficiency and oxygen surplus as well as the
measuring function for toxic gases. For certified gases and
measured values, see the enclosed supplementary
documentation (part no. 90 33 655).
CSA-specific information:
Only the combustible gas part of this instrument has been
tested for measuring accuracy.
Radio approval (X-am 8000 only):
The information for radio approval can be viewed in the menu.
For further information, see the following chapter: "Opening
information", page 33.
Accessories relevant to approval:
This chapter contains an overview of the key parts covered by
the BVS and PFG certification. Information on other parts can
be found in the spare parts list or requested from the service
of Dräger. The ambient conditions that apply for the gas
detector also apply for the accessories. For further
information see: "Gas detector", page 43.
Description
Carrying strap
Calibration adapter CAL 2.0
Pump adapter with dust and
water filter
Pump adapter "Nona" with
dust and water filter
Induction charger
The data logger is not part of the technical suitability test.
3.5
Label
The energy supply label has a mark for a service label. Here,
a maximum of one service label and one year-point label may
be attached one on top of the other. Further labels, conductive
labels or labels with conductive material or parts can have a
negative effect on inductive charging.
The name plate on the gas detector and the alarm
elements must not be concealed.
Instructions for use
|
X-am
Part number
8326823
3720224
8326820
3720225
8325825
®
3500
3.6
Sensor slots X-am 3500
Term
Sensor slot
HPP 1 (High Power Port)
HPP 2 (High Power Port)
EC 1-3 (Electro Chemical)
4
Operation
4.1
Operating concept
Navigation is done with the 3 multifeature buttons and the
dynamic navigation bar (see Graphic E on the fold-out page).
The navigation bar changes dynamically depending on the
available interactions.
4.2
Symbol explanations
4.2.1 feature buttons
Symbol
Explanation
Confirm action/dialog / return to menu
Confirm all
Scroll up / through display
Scroll down / through display
Cancel action
Display quick menu
Display measuring channels individually
Display all measuring channels
Increase value
Decrease value
Repeat feature
Display menu
4.2.2 Displays
Symbol
Explanation
Horn and vibration for gas alarm deacti-
vated
4.2.3 Application
Symbol
Explanation
Measuring
Fresh air calibration
Bump test or calibration
Operation
Configuration
not assigned
CatEx sensor
EC sensors
|
en
29
Advertenties
Hoofdstukken
Inhoudsopgave
