1. INTRODUCTION AND SAFETY INSTRUCTIONS
Thank you for purchasing a high-quality Berger LED television. We hope you enjoy your new
television. Even if you are familiar with the use of similar appliances, please read this operating
manual to become more familiar with all the functions of the television.
Safety instructions
For your own safety and to prevent unnecessary damage to your television, please read and ob-
serve the following safety instructions before using the television:
Intended use and environmental conditions:
This television is intended solely for the reception and reproduction of picture and sound signals.
It must not be operated in rooms with high humidity (e.g. bath or sauna). The warranty is only
granted for use in the specified permissible environment.
If the unit is used outdoors, ensure that it is protected from moisture (rain, dripping and splashing
water). High humidity causes leakage currents in the unit. This can lead to a risk of contact with
voltages or a fire. If you have brought the unit out of the cold into a warm environment, leave
it switched off for about one hour because of the possible formation of condensation moisture.
Do not place any objects filled with liquid or burning candles on the unit. Depending on the
mounting or stand solution selected, there is a risk of crushing between the TV housing and the
stand. When turning the TV set, make sure that no fingers or objects are in this area. Batteries
pose a potential choking hazard. Therefore, do not allow children to open the battery storage
compartment.
Attention! Laser class 1:
The remote control has an infrared diode of laser class 1. Do not look at it with optical
devices to avoid eye injuries.
Transport:
Hold the unit by the edges of the housing at the bottom and top. The display is made of glass or
plastic and may break if handled improperly. No guarantee will be given for damage caused by
external influences.
Power supply:
Incorrect voltages may damage the unit. This unit may only be connected to a 12V or, via a suita-
ble power supply unit, to a 230V AC mains supply. Lay the power supply cable so that it cannot
be damaged. The mains or connection cable must not be bent or laid over sharp edges, must
not be walked on and must not be exposed to chemicals - the latter applies to the entire unit! A
power cable with damaged insulation can cause electric shocks and is a fire hazard. If the TV set
is operated on the 230V mains, the mains plug of the TV set must be easily accessible so that the
set can be disconnected from the mains at any time. When disconnecting the mains plug, do not
pull on the cable but on the plug housing. The cables in the mains plug could be damaged and
cause a short circuit when reconnected.
Air circulation and high temperatures:
The ventilation slots on the rear wall of the set must always remain unobstructed. Please do not
place any newspapers or blankets on/over the TV set. If the TV set is placed or hung in a cabinet
or on a shelf, there must be at least 2 cm of free space at the sides and at the top for air circula-
tion. Like any electronic device, your TV set needs air for cooling when it is in operation. If the air
circulation is obstructed, fires may occur.
GB
31