Inhoudsopgave
Advertenties
EN
any circuit breaker or fuse.
WARNING! This appliance can be used by children aged from 3 years and above and
persons with reduced physical, sensory or mental capabilities, or lack experience and
knowledge, if they have been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved. Children shall not play with
the appliance. Cleaning and user maintenance shall not be made by children without
supervision.
WARNING! When using the appliance there is a risk of hot water scalding!
WARNING! Do not touch the appliance and its control panel with wet hands or if you are
barefoot or standing on a wet spot!
WARNING! When using the device is PROHIBITED to clog the winch so as to reduce the
water flow, because this will cause increased water pressure in the water tank, and can lead
to activation of the built-in safety valve.
WARNING! Periodically check for possible reduction in winch section caused most likely
by the deposition of limestone. Upon finding such it should be carefully removed.
WARNING! In case of failure of the power cord and / or plug, contact your nearest
authorized by the manufacturer or vendor service company, because the cord with plug
must be replaced by the manufacturer, its service agent or a person with similar
qualifications to avoid danger.
WARNING! You should not use the appliance in case of doubt that the water within the
water tank is frozen (room temperature is or recently was below 0°C or it is expected to be).
It is MANDATORY to drain the water from the water tank - see section "Maintenance and
prevention." It is PROHIBITED to operate the device in question that the water in it is frozen.
WARNING! The water supply of the appliance by another water heater or system is
prohibited!
ENVIRONMENTAL PROTECTION
This appliance is marked according the European directive concerning
waste electric and electronic equipment (WEEE). By ensuring this product is
disposed of correctly, you will help prevent potential negative consequences
for the environment and human health, which could otherwise be caused by
inappropriate waste handling of this product.
The symbol on the product, or on the enclosed documents indicates that this
appliance may not be treated as household waste. Instead it should be
handed over to the applicable collection point for the recycling of electrical
and electronic equipment. Disposal must be carried out in accordance with
local environmental regulations for waste disposal. For more detailed
information about treatment, recovery and recycling of this product, please
contact your local city office, your household waste disposal service or the
shop where you purchased the product.
TECHNICAL DESCRIPTION
The water heater is intended for use only for domestic purposes in the
household and is used to heat water from common water supply network,
which composition and features comply with the specified values in water
quality legislation. The water heater is connected to the general water
supply network and provides hot water for washing only on the spot (sink)
where it is installed. The water is heated at the time of flowing through the
unit water tank.
There are three main models of water heaters each with two modifications:
џ Model Е41 – with mixer tap with two handles and 3,5kW power
џ Model Е42 – with ceramic mixer tap with one handle and 3,5kW power
џ Model Е51 – with mixer tap with two handles and 5kW power
џ Model Е52 – with ceramic mixer tap with one handle and 5kW power
џ Model Е71 – with mixer tap with two handles and 6,5kW power
џ Model Е72 – with ceramic mixer tap with one handle and 6.5kW power
On Fig. 1 is displayed the general view of water heater model E41. The
manufacturer reserves the right to change the general appearance and
fittings, while maintaining the appliance safety and functionality.
WATER HEATER CONNECTION TO THE WATER
SUPPLY NETWORK
The installation of the heater and mixing tap is carried out in the following
sequence - please refer to Fig. 1:
џ The mixing tap (2) is screwed into the socket of cold water plumbing
(3). The socket is not supplied with the delivery package. In order to
ensure connection tightness may be used Teflon tape or other suitable
substitute. For tightening use a suitable for the tap slot wrench. Once
tightening and connection tightening are completed, the tap should be
placed in a horizontal position so that after heater installation, the
latter is in a vertical position with the pipes down.
џ To the mixing tap outlet is mounted ONLY the winch (1) supplied in the
d e l i v e r y
WARNING! Violating this requirement shall impede the appliance
safety and functionality.
џ Unscrew the nuts 3/8"(5) from the tap and take out the seals (4).
џ Remove the two transport caps placed on the inlet/outlet pipes (6,7).
џ Place the nuts on the water heater pipes (5) and then the seals (4).
10
EN
s e t .
Advertenties
Inhoudsopgave
