Inhoudsopgave
Advertenties
•
Press the release handle down and press the table slowly and carefully downwards until it turns
180° on its hinges (20) and is locked secure with the underside facing downwards.
•
Hold the top of the saw. Pull out the lock pin and turn it 90° clockwise. Hold the lock pin, slowly lift
the top of the saw and release the lock pin. Lock the top part in the raised position.
•
Connect the depth stop.
•
Hold the movable blade guard and release the adjustment knob for the cleaver blade. Push it to the
left so that it is no longer outside the saw blade. Lower the movable blade guard fully and angle the
cleaver blade up into place. Tighten the adjustment knob.
Fitting the side rail
The side rails (n) are useful when sawing thin and thick workpieces. Fit them in place using the connector
rods (o) and tighten the screws (p).
Remove when sawing wide or low workpieces.
Adjusting mitre angle
Unscrew the two adjustment screws on the fence guide and turn the turntable to the required angle (up to
45° to left or right). Screw tight the adjustment screws.
Adjusting bevel angle
Slacken the bevel adjustment knob and tip the top part of the saw to the left until the required angle is
obtained in relation to the worktable. Tighten bevel adjustment knob.
ENGLISH
47
Advertenties
Inhoudsopgave
