Advertenties
Beschikbare talen
Beschikbare talen
a joint as shown below, in which the edge of
the plate is angled (Fig. V).
V
Fillet weld connections
A fillet weld is created if the workpieces are
perpendicular to each other. The weld should
be shaped like a triangle with sides of equal
length and a slight fillet (Fig. W, X).
Welds on an inner edge
The preparation for this weld joint is very
simple and is carried out for thicknesses of
5 mm. The dimension "d" needs to be
reduced to a minimum and should always be
less than 2 mm (Fig. W).
W
However, it is no longer expedient for thicker
materials. In this case, it is better to prepare
a joint as shown in Figure V, in which the
edge of the plate is angled.
X
Overlap welds
The most common preparation is that with
the straight weld edges. The weld can be
released using a standard angle weld seam.
Both workpieces must be brought as close to
each other as possible, as shown in Fig. Y.
Y
z Maintenance
Remove dust and contamination from
„
the device regularly.
Clean the device and accessories
„
with a fine brush or a dry cloth.
z Information about recycling
and disposal
HOLD WASTE! DON'T THROW AWAY –
RECYCLE!
According to European Directive 2012/19/EU,
used electrical devices must be collected sepa-
rately for environmentally compatible recycling or
recovery. The symbol of the crossed out dustbin
means that this device must not be disposed of in
household waste at the end of its service life. The
device must be handed in at established collection
points, recycling centres or waste management
depots. The disposal of defective devices which
you have sent in will be carried out free of charge.
In addition, distributors of electrical and electronic
equipment as well as food distributors are obliged
to accept returned waste. Lidl provides you with
return options directly in its branches and shops.
Return and disposal is free of charge for you.
When buying a new device you have the right
GB/IE/NI/CY/MT
DO NOT DISPOSE
OF ELECTRICAL
TOOLS IN HOUSE-
21
Advertenties
