Initial Operation; Setting The Current Time; Timer Function - WMF Lumero Gebruiksaanwijzing
Verberg thumbnails
Zie ook voor Lumero:
- Gebruiksaanwijzing (84 pagina's) ,
- Gebruiksaanwijzing (34 pagina's) ,
- Gebruiksaanwijzing (56 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Initial operation
Prior to the first use and after the device has not been operated for an extended period of time, run
a brew cycle with fresh water without coffee grounds. To do so, fill the tank to no higher than the
10-cup mark (version with glass jug) or to the 8-cup mark (version with thermal jug), as otherwise
the jug can overflow.
Setting the current time
After connecting the mains plug to a socket, the time appears on the display. The standard time is set
as 12:00. You can correct the set time at any time by pressing the Timer symbol
for at least three
seconds. The dots between the hours and the minutes start to flash. Press the + and - symbols to set
the correct time. Confirm the time by pressing the Timer symbol
. If you do not make any changes,
after approximately 15 seconds the standard time is displayed.
Note: The time must be reset after a power failure or after the mains plug has been unplugged.
Coffee preparation
For easy filling of the water tank you can remove it. The lid on the water tank can be removed. Only
pour cold water into the tank. The water level indicator is for the amount of fresh water that is
needed to brew the desired number of cups per 125 ml coffee.
In order to pour in the ground coffee, open the swing filter by pressing the release button on the
water tank. Place the paper filter of the 1 x 4 size into the filter, but fold the stamped edge before
doing so. The paper filter should not protrude over the edge of the filter. If necessary, push it down
slightly with your hand.
Add the required amount of ground coffee. Depending on your personal taste, use approximately 5–7
g of medium-fine ground coffee per cup. If it is ground too finely, the filter can overflow.
Then close the swing filter. It will audibly click into place.
Immediate start
Briefly press the Start/Stop symbol if the coffee is to be prepared immediately. The symbol lights up
during the brewing process.
You can cancel the preparation at any time by pressing the Start/Stop symbol.
Wait a few minutes until all of the coffee has run into the jug. After removing the jug, a drip-stop
prevents coffee from dripping.
Timer function
The device's timer function starts the brewing process automatically at the desired time. The switch-on
time can be programmed up to 24 hours in advance.
Programming the switch-on time
and the + and - symbols light up. Set the
Press the Timer symbol once briefly. The Timer symbol
desired switch-on time by pressing the + and - symbols and confirm the switch-on time by pressing
the Timer symbol
.
If you do not press the Timer symbol to confirm the switch-on time, the dots between the hours
and the minutes on the display flash. After about 15 seconds, the display switches back to the time
without saving a switch-on time. To activate the automatic brewing process, see the next section of
the operating instructions.
Note: The switch-on time must be reset after a power failure or after the mains plug has been
unplugged.
10
Advertenties
Inhoudsopgave
