Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
All manuals and user guides at all-guides.com
1. Turn power off and disconnect the test leads from
the multimeter
2. Open the rear battery cover by removing two screws
(B) using a Phillips head screwdriver
3. Insert the battery into battery holder, observing the
correct polarity
4. Put the battery cover back in place., secure with the
screws
WARNING: To avoid electric shock, do not
WARNING: To avoid electric shock, do not
operate the meter until the battery cover is in
operate the meter until the battery cover is in
place and fastened securely.
place and fastened securely.
If the multimeter does not work properly, check
the fuses and batteries to make sure that they
are still good and properly inserted.
Fuse replacement
WARNING: To avoid electric shock, disconnect
WARNING: To avoid electric shock, disconnect
the test leads from any source of voltage
the test leads from any source of voltage
before removing the multimeter cover.
before removing the multimeter cover.
1. Disconnect the test leads from the multimeter
2. Remove the protective rubber holster.
3. Remove the battery cover (two 'B' screws) and the
battery
4. Remove the six 'A' screws securing the rear cover
5. Gently remove the old fuse and install the new fuse
into the holder
6. Always use a fuse of the proper size and value
(0.5 A/1000 V fast blow for the 400 mA range [SIBA
70-172-40], 10 A/1000 V fast blow for the 20 A range
[SIBA 50-199-06])
7. Replace and secure the rear cover, battery and battery
cover.
WARNING: To avoid electric shock, do not
WARNING: To avoid electric shock, do not
operate your multimeter until the fuse cover is
operate your multimeter until the fuse cover is
in place and fastened securely.
in place and fastened securely.
Nieaf-Smitt is a brand name of Mors Smitt
65
www.nieaf-smitt.com
Advertenties
Hoofdstukken
Inhoudsopgave
