7. Clean the condensator, air intake and exhaust
opening with a brush or vacuum cleaner.
8. Clean the drain hole with a cotton swab.
9. After cleaning, reconnect the appliance to the
mains and switch it on.
10. Put the food back in.
Fittings
All the variable components of the appliance can be
removed for cleaning (see section headed Fittings).
Smells
If you notice unpleasant smells:
1. Switch off the appliance.
2. Remove all food from the appliance.
3. Clean the inside of the appliance (see section
headed Cleaning the appliance).
4. Clean all packaging.
5. Pack strongly smelling food in air-tight containers to
prevent odours.
6. Switch on the appliance again.
7. Arrange the food.
8. After 24 hours, check again to see if the smells
have reappeared.
Saving energy
Install the appliance in a dry, well ventilated room.
■
The appliance must be installed out of direct sunlight
and away from heat sources (e.g. heating elements,
cooker).
Use an insulating plate if necessary.
Allow hot food and drinks to cool before placing
■
them in the appliance.
Place frozen food in the fridge compartment to
■
defrost and utilise the low temperature of the frozen
food to cool other food.
Only open the appliance door for as short a time as
■
possible.
To prevent the food warming up quickly in the event
■
of a power cut or a fault, place blocks of ice in the
top compartment directly on top of the food.
Make sure that the appliance door is always closed.
■
The arrangement of the equipment parts shown in
■
the section Getting to know the appliance requires
the least amount of energy. Any other arrangements
can result in higher energy consumption.
To prevent increased power consumption,
■
occasionally clean the air vent with a soft brush or
vacuum cleaner.
Operating noises
Completely normal noises
Humming
Motors running (e.g. refrigeration units, ventilator).
Bubbling, whirring or gurgling noises
Refrigerant circulating through the pipes.
Clicking
Motors, switches or solenoid valves are switching on/
off.
Preventing noises
The appliance is not standing straight
Make sure the appliance is exactly aligned by using a
spirit level. To adjust the position of the appliance, use
the adjustable feet or place something underneath.
The appliance is touching adjacent units or
appliances
Move the appliance away from adjacent furniture or
appliances.
Containers or shelves are wobbling or sticking
Check the removable parts and re-insert them if
necessary.
Containers are touching
Move the containers apart slightly.
en
23