CFF12, CFF18, CFF20, CFF35, CFF45, CFF70DZ
Problem
The display shows an
error message (e.g.
"Err1") and the appli-
ance does not cool.
7.1
Lid past built-in stop (CFF35, CFF45 only)
If the lid has been forced past the built-in stop, proceed as follows (fig. e, page 12):
➤ Support the lid with one hand (A).
➤ Hold the latch down with the other hand (B).
!
CAUTION! Health hazard
Failure to obey this caution could result in minor or moderate injury.
Beware pinching your thumb while closing the lid.
A
NOTICE! Damage hazard
Failure to observe this instruction can cause the lid to break off.
➤ Close the lid as far as possible without pinching your thumb, while still holding
the latch down, to keep it from breaking.
✔ The lid should now be approximately at the angle shown (fig. e, page 12).
➤ Remove the hand from the latch (B), and continue closing the lid all the way.
I
NOTE
The hinges may release from the correct position during the final closing
action. Reposition the lid as follows:
• Operate the latches on both sides of the lid simultaneously.
• Lift and reposition the lid.
8
Warranty
The statutory warranty period applies. If the product is defective, please contact your
retailer or the manufacturer's branch in your country (see dometic.com/dealer).
For repair and warranty processing, please include the following documents when
you send in the product:
• A copy of the receipt with purchasing date
EN
Possible cause
The appliance has
switched off due to an
internal fault.
Remedy
This can only be repaired by an
authorized repair center.
Warranty
31