Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
24 Progress
Problem
Water flows on the floor.
The temperature in the appli-
ance is too low/too high.
There is too much con-
densed water on the rear wall
of the refrigerator.
Door does not open easily.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
Replacing the lamp
The appliance is equipped with
a longlife LED interior light.
CAUTION! Disconnect the plug
from the mains socket.
Possible cause
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are stor-
ed at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
Door was opened too fre-
quently.
Door was not closed com-
pletely.
Stored food was not wrap-
ped.
You attempted to re-open
the door immediately after
closing.
1. At the same time, with the fingers
expand up and down the transparent
cover and unhook it in the direction of
the arrows.
Solution
Attach the melting water out-
let to the evaporative tray.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces-
sary.
Open the door only when
necessary.
Make sure the door is closed
completely.
Wrap food in suitable pack-
aging before storing it in the
appliance.
Wait a few seconds between
closing and re-opening of the
door.
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
