Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
CAUTION! If you need to replace the fuse make sure to use a fuse of the same type (T2A L,
250 V).
To replace the fuse, proceed as follows:
1. Rotate the screw cap (d) counter-clockwise and remove it from the
cigarette lighter plug housing (a). If necessary, use pliers.
2. Replace the fuse (b) with a new T2A L, 250 V type fuse. You can
purchase a suitable fuse from any electronics retail outlet.
3. First insert the fuse (b) into the cigarette lighter plug housing (a).
4. Insert the metal contact (c) into the screw cap (d).
5. Next, insert the screw cap (d) with the inserted metal contact (c) over the fuse (b) and then screw the
cap (d) clockwise onto the cigarette lighter plug housing (a).
15. Troubleshooting
You can solve most common problems yourself using the table below. If the problem persists after
checking the suggested solutions, please contact our Service Hotline (see "Warranty and service
information" on page 51). Do not attempt to repair the product yourself. Do not open the housing of the
Dashboard Camera or of the car charger as they contain no serviceable parts.
Error
Unable to power the
Dashboard Camera on.
The Dashboard Camera
suddenly powers off.
The Dashboard Camera fails to
respond and cannot be
switched off.
Solution
The battery pack is empty. Recharge the battery.
The battery pack is empty. Recharge the battery.
Auto power-off is enabled. Check the settings (see "Auto Power Off"
in the "Setup menu" section on page 42).
Press the Reset switch (17). Use a pointed object to do this. Wait for a
few seconds. The Dashboard Camera should then work as normal
again. After performing a reset, all user-defined settings are lost,
except the date and time.
CR 3 A2
English - 49
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
