Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
WallPerfect W 665
Problem
Spray jet pulsates
Coating material
causes "paint tears"
Too much fog of
coating material
(Overspray)
Device does not
function
Paint in the
ventilating hose
Poor covering
capacity on the wall
The guarantee runs for two years, counting from the date of sale (sales slip). It covers and
is restricted to free-of-charge rectification of faults which are demonstrably attributable
to the use of faulty materials in manufacture, or assembly errors; or free-of-charge
replacement of the defective parts. The guarantee does not cover incorrect use or
commissioning or fitting or repair work which is not stated in our operating instructions.
Wearing parts are also excluded from the guarantee. The guarantee excludes commercial
use. We expressly reserve the right to fulfil the guarantee. The guarantee expires if
the tool is opened up by persons other than WAGNER service personnel. Transport
damage, maintenance work and loss and damage due to faulty maintenance work
are not covered by the guarantee. Under any guarantee claim, there must be proof
of purchase of the tool through submission of the original receipt. Wherever legally
possible, we exclude all liability for injury, damage or consequential loss, especially if the
tool has been used for a purpose other than that stated in the operating instructions,
commissioned or repaired other than in accordance with our operating instructions
or if repairs are performed by someone who is unqualified. We reserve the right to
perform any repairs in excess of those stated in our operating instructions. In case of
guarantee or repair, please refer to your point of sale.
Cause
•
Coating material in
container running out
•
Nozzle seal worn
•
Air filter heavily soiled
•
Too much coating material
applied
•
Viscosity of coating material
too low
•
Distance to the object too
large
•
Too much coating material
applied
•
Device overheated
•
Diaphragm soiled
•
Diaphragm defective
•
Spray material is too cold
•
Highly absorbent surface
or paint with poor covering
capacity
•
Distance too large
2 years guarantee
Remedy
Refill
➞
Replace
➞
Change
➞
Turn material volume
➞
adjusting screw to the left (-)
Reduce distance
➞
Turn material volume
➞
adjusting screw to the left (-)
Unplug the power plug,
➞
let the device cool down
approx. 30 minutes, do not
bend the hose, check the
air filter, do not cover the
intake slots
Clean the diaphragm
➞
Replace the diaphragm
➞
Heat spray material
➞
maximum 40°C)
Cross spray (Fig. 13)
➞
Closer to the object
➞
GB
(to
23
Advertenties
Inhoudsopgave
