Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
WallPerfect W 665
Coating Materials Suitable for Use
Interior wall paint (dispersions and latex paint)
Coating Materials Not Suitable for Use
Materials that contain highly abrasive components, facade paint, caustic solutions and
acidic coating substances. Materials with a flash point below 21°C.
The following materials can only be processed with optional accessories:
Water- and solvent-based paints, finishes, primers, 2-component paints, clear finishes,
automotive finishes, staining sealers and wood sealer-preservatives.
Preparation of the workplace
Sockets and plugs must be masked. Risk of an electric shock as a
consequence of sprayed material entering the socket!
Mask all the areas and objects that are not to be spray painted, or
remove them from the work area.
Silicate paint corrodes glass and ceramic surfaces upon contact! All
such surfaces must therefore be completely covered.
Preparation of the Coating Material
Spray material that is at least at room temperature (e.g. diluted with warm
i
water) provides a better spray result.
Attention! Do not heat spray material above 40°C.
Interior wall paints can be sprayed undiluted or slightly diluted with the spray attachment
provided. Detailed information is available in the technical data sheet of the manufacturer
( Internet Download).
1.
Stir the material thoroughly and dilute it in the container as per the recommended
dilution (an agitator is recommended for stirring).
Sprayed material
Interior wall paint (dispersions and latex paint)
2.
If the feed rate is too low even at maximum flow setting, dilute in steps of 5 - 10 % until
the feed rate meets your requirements.
Startup
Before connecting to the mains supply, be sure that the supply voltage is identical with
the value given on the rating plate.
•
Attach the carrying strap to the unit.
•
Unscrew the container from the spray gun.
Thinning recommendation
(Fig. 2)
GB
dilute by 10 %
17
Advertenties
Inhoudsopgave
