Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
GB
Further information about the WAGNER range of products for renovating is available
under www.wagnergroup.com
Environmental protection
The appliance and accessories should be recycled in an environmentally
friendly way. Do not dispose of the appliance with household waste. Support
environmental protection by taking the appliance to a local collection point or
obtain information from a specialist retailer.
Important Note regarding Product Liability!
Due to an EC ordinance in effect since 01.01.1990, the manufacturer is liable for his product
only if all parts originate from or were approved by the manufacturer and the devices
are assembled and operated correctly. The use of other accessories and spare parts can
partially or completely invalidate the liability.
Correction of Malfunctions
Problem
No coating material
emerges from the
nozzle
Coating material
drips from the
nozzle
Atomisation too
coarse
22
Cause
•
Nozzle clogged
•
Material volume setting
turned too far to the left (-)
•
No pressure build-up in
container
•
Container empty
•
Feed tube loose
•
Feed tube clogged
•
Ventilating bore (Fig.12, C)
clogged
•
Coating material assembly
at air cap, nozzle or needle
•
Nozzle loose
•
Nozzle seal worn
•
Nozzle worn
•
Material volume too large
•
Material volume adjusting
screw turned too far to the
right (+)
•
Nozzle contaminated
•
Viscosity of coating material
too high
•
Too little pressure build-up
in container
•
Air filter heavily soiled
WallPerfect W 665
Remedy
Clean
➞
Turn to the right (+)
➞
Tighten container
➞
Refill
➞
Insert
➞
Clean
➞
Clean
➞
Clean
➞
Union nut tighten
➞
Change
➞
Change
➞
Turn material volume
➞
adjusting screw to the
left (-)
Clean
➞
Dilute further
➞
Tighten container
➞
Change
➞
Advertenties
Inhoudsopgave
