Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
26 Progress
Problem
Water flows on the rear
plate of the refrigerator.
Water flows inside the refrig‐
erator.
Water flows on the floor.
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.
Possible cause
The water drainage plug is
not correctly positioned.
Temperature is set incor‐
rectly.
During the automatic de‐
frosting process, frost
melts on the rear plate.
Food products prevent the
water to flow into the wa‐
ter collector.
The water outlet is clog‐
ged.
The melting water outlet is
not connected to the evap‐
orative tray above the
compressor.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
The food products' tem‐
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been
opened often.
There is no cold air circu‐
lation in the appliance.
Replacing the lamp
Solution
Position the water drainage
plug in the correct way.
Refer to "Operation" .
This is correct.
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Attach the melting water outlet
to the evaporative tray.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products temper‐
ature decrease to room tem‐
perature before storage.
Add less food products at the
same time.
Defrost the appliance.
Open the door only if necessa‐
ry.
Make sure that there is cold
air circulation in the appliance.
The appliance is equipped with
a long-life LED interior light.
It is strongly recommended to
use original spare parts only.
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
