Programming The Master Transmitter; Programming Additional Transmitters - Becker Centronic VarioControl VC360-II Montage- En Gebruiksaanwijzing

Draadloze ontvanger dc solar

Inhoudsopgave

Advertenties

Beschikbare talen

Programming the master transmitter

The master transmitter refers to the very first transmitter

programmed in a receiver. In contrast to subsequently pro-

grammed transmitters, the master transmitter enables,

among other things, the setting of limit positions (for drives

with integrated radio receiver) and the programming or de-

leting of further transmitters. Any transmitter that has separ-

ate UP, STOP, DOWN buttons and a programming button can

be a master transmitter.

If a transmitter is already programmed in the receiver, press

the programming button of the transmitter for 10 seconds.

Press the programming button of the transmitter for 3 seconds whilst in pro-

gramming mode.

► The receiver confirms.

Programming is now complete.

In addition to the master transmitter, up to 15 further trans-

mitters (of which a maximum of three can be sensors) can be

programmed in the radio receiver.

Press the programming button of the master transmitter for 3 seconds.

▻ The receiver confirms.

Now press the programming button of a new transmitter which has not yet

been programmed in the radio receiver for 3 seconds. Doing so activates the

programming mode of the radio receiver for a new transmitter for 3 minutes.

▻ The receiver confirms.

Now press the programming button of the new transmitter you wish to pro-

gram again for 3 seconds.

▻ The receiver confirms.

► The new transmitter has now been programmed.

32 - en

Inhoudsopgave

Advertenties

Inhoudsopgave