Intended Use - Becker Centronic VarioControl VC360-II Montage- En Gebruiksaanwijzing

Draadloze ontvanger dc solar

Inhoudsopgave

Advertenties

Beschikbare talen

The radio receiver described in these instructions must only be used for the

operation of roller shutter, screen and blind control units. This control unit is

only compatible with our Ø35 mm DC tubular drives. When switched off, the

drive connection is short-circuited. The connection of external devices must

be carried out in consultation with specialist retailers.

• Please note that radio-controlled systems may not be used in areas with

a high risk of interference (e.g. hospitals, airports).

• The remote control is intended solely for use with equipment and sys-

tems in which malfunctions in the transmitter or receiver would not pose

any risk to persons, animals or property, or which contain safety devices

to eliminate such risks.

• The operator is not protected from interference from other telecommu-

nications systems and terminal equipment (e.g. even from radio-con-

trolled systems which are properly operated in the same frequency

range).

• Only connect radio receivers to devices and systems approved by the

manufacturer.

•

Ensure that the control unit is not installed or operated

close to metal surfaces or magnetic fields.

•

Radio-controlled systems transmitting on the same fre-

quency may cause reception interference.

•

Note that the range of the radio signal is limited by legis-

lation as well as by design.

Intended use

25 - en

Inhoudsopgave

Advertenties

Inhoudsopgave