Installation (Fig. A-C); Operation; Reaching The Decided Room Temperature - SilverCrest SOR 2400 D2 Bedienings- En Veiligheidsinstructies
Verberg thumbnails
Zie ook voor SOR 2400 D2:
- Bedienings- en veiligheidsinstructies (53 pagina's) ,
- Bedienings- en veiligheidsinstructies (113 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Do not use the product in the
immediate surroundings of a
bath, a shower or a swimming
pool .
Do not use the product if it has
been dropped .
Do not use the product if there
are visible signs of damage .
Use the product on a
horizontal and stable surface .
˜ Installation (fig. A–C)
Place the product upside down on a soft
underlay to avoid scratch on the surface,
power cord retainer
temperature control
Attach the U shape bolt
between first two fins with the threaded ends
pointing upward (fig . A) .
Place the U shape castor assembly
over the U shape bolt
pointing upward (fig . B) . Ensure both
threaded ends of U shape bolt
through both holes on the U shape castor
assembly
.
11 ]
[
Fasten wing nut
threaded end of U shape bolt
Repeat above steps on the rear side of the
product with the I shape castor assembly
and the U shape bolt
last two fins (fig . C) .
12 GB/IE/NI
upper than
[
7 ]
(fig . A) .
3 ]
[
to the product
10 ]
[
11 ]
[
with both wheels
[
10 ]
passing
10 ]
[
securely onto each
[
8 ]
.
10 ]
[
attached between
[
10 ]
Set the product back to upright position,
wheels on the floor . The product is now
ready to use .
NOTE: The product is equipped with a
tilt protection switch . It will shut down the
product automatically if it falls over or is
lying on its side .
˜ Operation
Unwind the power cord completely from the
power cord retainer
Make sure that both, temperature control
and heat level switch
respectively .
Connect the product to a grounded mains
socket protected by a residual current circuit
breaker . Ensure that the mains voltage of
the electrical outlet meets the requirements
described in the "Technical data" chapter .
NOTE: Ensure the mains plug is fully
inserted to the mains socket .
˜ Reaching the decided
room temperature
Set the temperature control
heat level switch
When the desired room temperature is
reached, turn the temperature control
gently counter-clockwise until the product
shuts off . A "click" sound is emitted . Leave
the temperature control
and the room temperature is now retained .
9 ]
[
The product automatically cycles on and off
to keep the desired room temperature .
Use the heat level switch
quickly the product shall warm up . To warm
up quickly, set the heat level switch
.
7 ]
[
and 0
are set to
2 ]
[
to
and the
3 ]
[
to 3 .
2 ]
[
3 ]
[
at the position
[
3 ]
to select how
[
2 ]
to 3 .
2 ]
[
3 ]
[
Advertenties
Hoofdstukken
Inhoudsopgave
