Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ENGLISH
VACUUM SYSTEM MOTOR FILTER CLEANING
1.
Drive the machine on a level ß oor.
2.
Turn the ignition key (58) to "0".
3.
Open the cover (20) and check that the recovery tank (19) is empty, otherwise empty it with the drain hose (24).
4.
Close the cover (20).
5.
Carefully lift the tank assembly (44).
6.
Check that the Þ lter (37) is clean. If necessary clean it with water and compressed air, then install it.
SOLUTION FILTER CLEANING
1.
Drive the machine on a level ß oor.
2.
Turn the ignition key (58) to "0".
3.
Close the solution tap (A, Fig. 10) under the machine, behind the right rear wheel. The tap (A) is closed when it is in the
position (B) and it is open when it is in the position (C).
4.
Remove the transparent cover (D) and the gasket (E), then remove the Þ lter strainer (F). Clean them with water and install
them on the support (G).
NOTE
The fi lter strainer (F) must be correctly positioned on the housing (H) of the transparent cover (D).
5.
Open the tap (A).
C
A
26
Bedienungsanleitung auf www.gluesing.net
USER MANUAL
B
SCRUBTEC R 466 - R 471 - R 471C - BOOST
G
F
E
D
Figure 10
®
R4
H
P100444
9098960000(1)2011-04 A
Advertenties
Hoofdstukken
Inhoudsopgave
