Download Inhoudsopgave Inhoud Print deze pagina

After Using The Machine; Pushing/Towing The Machine; Machine Long Inactivity; First Period Of Use - Nilfisk SCRUBTEC R 466 Gebruiksaanwijzing

Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

Cylindrical brush debris container emptying (only for cylindrical brush deck)
14.
Stop the machine.
15.
Lower the cylindrical brush deck and remove the debris container (F, Fig. 2).
16.
Empty and wash the debris container (F), and then install it on the relevant stand.

AFTER USING THE MACHINE

After working, before leaving the machine:
1.
Remove the brushes/pad-holders as shown in the relevant paragraph.
2.
Empty the tanks (19 and 22) as shown in the previous paragraph.
3.
Remove the squeegee (30) and clean it with hot water.
4.
Perform the daily maintenance procedures (see the Maintenance chapter).
5.
Store the machine in a clean and dry place, with the brushes/pad-holders and the squeegee lifted or removed.

PUSHING/TOWING THE MACHINE

To push/tow the machine easily when the drive system cannot be used (for example in case of missing batteries, discharged
batteries, etc.), disengage the electromagnetic brake by pulling the lever (7) and locking it with a spacer.
When the operation is over, remove the spacer under the lever (7) to activate the electromagnetic brake again.
WARNING!
If the lever (7) is not disengaged after pushing/towing the machine, the electromagnetic brake is disengaged.
WARNING!
Do not start the machine when the electromagnetic brake is disengaged.
For safety reasons, it is recommended to disengage the electromagnetic brake only for the time necessary to
manually move the machine.

MACHINE LONG INACTIVITY

1.
If the machine is not going to be used for more than 30 days, proceed as follows:
2.
Perform the procedures shown in After Machine Use paragraph.
3.
Before disconnecting the battery red connector (9) perform the following procedures:
Open the cover (20) and the Þ ller neck (23), then check that the tanks (19 and 22) are empty, otherwise empty them.
Keep the recovery tank assembly (19) lifted by using the stand (25).

FIRST PERIOD OF USE

After the Þ rst 8 hours, check the machine fastening and connecting parts for proper tightening. Check the visible parts for integrity
and leakage.
9098960000(1)2011-04 A
Bedienungsanleitung auf www.gluesing.net
SCRUBTEC R 466 - R 471 - R 471C - BOOST
USER MANUAL
®
R4
ENGLISH
21

Advertenties

Inhoudsopgave
loading

Deze handleiding is ook geschikt voor:

Scrubtec r 471Scrubtec r 471cScrubtec boost r4

Inhoudsopgave