Programming The Run Times - Becker Centronic VarioControl VC120 Montage- En Gebruiksaanwijzing

Draadloze ontvanger voor rolluiken en cassetteschermen

Inhoudsopgave

Advertenties

Beschikbare talen

Note

Programming of the run times is only possible with

transmitters which support the function "MemoCon‐

trol".

Each receiver can save one switching time for one UP and one

DOWN cycle.

In the "

" slide switch position, this roller shutter action is repeated

every 24 hours.

It does not matter what position the

programming the switching time. Any stored switching times are

overwritten.

If necessary, run the roller shutter to the opposite limit position.

Wait for the time you wish the automatic drive command to be

executed.

At the desired time, press and hold the relevant direction button

until the roller shutter drive briefly stops after approx. 6 seconds

and then continues to the limit position.

Release the direction button.

The receiver has saved the current time for this direction of travel.