Programming The Transmitter; Programming The Master Transmitter; Programming Additional Transmitters - Becker Centronic VarioControl VC120 Montage- En Gebruiksaanwijzing

Draadloze ontvanger voor rolluiken en cassetteschermen

Inhoudsopgave

Advertenties

Beschikbare talen

Programming the transmitter

1. Connect the VC120 to the power supply.

2. Switch on the power.

3. The VC120 goes into the programming mode for 3 minutes.

a) Programming the master transmitter

Press the programming button of the master transmitter for 3 sec‐

onds when it is ready to programme.

[ The shading solution moves to confirm programming, i.e. the

shading solutions moves a few centimetres. This movement

will hereafter be referred to as "shifting".

Æ The programming process is now complete.

Note

If a transmitter is already programmed on the receiv‐

er, press the programming button for 10 seconds.

b) Programming additional transmitters

Note

In addition to the master transmitter, up to 15 fur‐

ther transmitters can be programmed in the VC120.

Press the programming button of the master transmitter program‐

med in a) for 3 seconds.

[ The shading solution shifts to confirm.

Now press the programming button of a new transmitter which has

not yet been programmed in the VC120 for 3 seconds. Doing so ac‐

tivates the programming mode of the VC120 for a new transmitter

for 3 minutes.

[ The shading solution shifts to confirm.

Now re-press the programming button of the new transmitter you

wish to programme for 3 seconds.

[ The shading solution shifts to confirm.

Æ The new transmitter is now programmed in.

Inhoudsopgave

Advertenties

Inhoudsopgave