Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
TEST mode
The TEST mode is activated by adjusting the threshold value. It automatically
ends after about 15 minutes. In TEST mode, the time for which the wind is
monitored is shortened.
Factory default settings
Wind threshold value
Programming the transmitter
Caution
Before programming the transmitter, check that the
threshold controller is as set at the factory. Make sure when
programming the transmitter that you are not in the travel re-
gion of the sun protection system.
1) Programming the master transmitter
a) Readying the receiver for programming
The master transmitter refers to the very first transmitter
programmed in a receiver. In contrast to subsequently pro-
grammed transmitters, the master transmitter enables,
among other things, the setting of limit positions and the
programming or deleting of further transmitters. Any trans-
mitter that has separate UP, STOP, DOWN buttons and a pro-
gramming button can be a master transmitter.
Follow the Assembly and Operating Instructions for the re-
ceiver.
Operate the programming button on the transmitter using a
suitable cylindrical tool (e.g. a ballpoint pen).
• Switch off the power supply to the receiver for 5 seconds, then switch it
back on
or
• Operate the programming button or the radio switch of the receiver.
The receiver is now in programming mode for 3 minutes.
20 - en
Left stop (about 2 m/s)
Advertenties
Hoofdstukken
Inhoudsopgave
Gerelateerde Handleidingen voor Becker Centronic SunWindControl SWC245-II
Gerelateerde Producten voor Becker Centronic SunWindControl SWC245-II
- Becker Centronic SunWindControl SWC241-II
- Becker CentronicPLUS SWC548 PLUS
- Becker CentronicPLUS SWC5416 PLUS
- Becker Centronic SunWindControl SWC545
- Becker Centronic SunWindControl SWC442-II
- Becker CentronicPLUS SWC541 PLUS
- Becker Centronic SunWindControl SWC441-II
- Becker Centronic SunWindControl SWC445-II