Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ENGLISH
AFTER MACHINE USE
1.
After working, before leaving the machine:
•
Turn off the vacuum system with the lever (75) and press the fi lter shaker switch (66) for a short interval, then turn on the
vacuum system again.
•
Empty the hopper (4) (see the procedure in the previous paragraph).
•
Lift the main broom with the lever (82).
•
Lift the side brooms with the levers (79) and (80).
•
Turn the engine throttle lever (77) to MIN (idle speed).
•
Turn off the machine by turning the ignition key (69) to "0", then remove it.
•
Engage the parking brake by pressing the pedal (84), then engage the brake lock control lever (76).
PUSHING/TOWING THE MACHINE
To easily push/tow the machine when it is off, proceed as follows:
–
Turn off the machine by turning the ignition key (69) to "0".
–
Open the hood (23) and secure it with the support rod (55).
–
Remove the screw (37).
–
Disengage the support rod (55) and close the hood (23).
–
Push or tow the machine.
–
After pushing/towing the machine, install the screw (37).
WORKING LIGHT ADJUSTMENT
If necessary, adjust the working light beam aiming (9) with the screws (21).
MACHINE LONG INACTIVITY
If the machine is not going to be used for more than 30 days, proceed as follows:
1.
Check that the machine storage area is dry and clean.
2.
Disconnect the negative connector (-) of the batteries (24).
3.
Handle the diesel engine (29) as shown in the relevant Manual.
FIRST PERIOD OF USE
1.
After the fi rst 8 hours, it is necessary to:
•
Check the machine fastening and connecting parts for proper tightening.
•
Check the visible parts for integrity and leakages.
2.
During the fi rst 50 hours, it is necessary to:
•
Let the engine run at idle speed for a few minutes before turning it off.
3.
After the fi rst 50 hours, it is necessary to:
•
Replace the engine oil and the oil fi lter (see the procedure in Maintenance chapter).
18
USER MANUAL
146 2275 000(2)2007-02 A
SR 1300H D
Advertenties
Hoofdstukken
Inhoudsopgave
