Download Inhoudsopgave Inhoud Print deze pagina

Troubleshooting; Scrapping - Nilfisk SR 1101 B Gebruiksaanwijzing

Verberg thumbnails Zie ook voor SR 1101 B:
Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

ENGLISH

TROUBLESHOOTING

Trouble
The machine does not start when
turning the ignition key to "I".
The machine does not move
when pressing the drive pedal.
The main broom does not work.
The side brooms do not operate.
The machine collects little debris/
dust.
The filter shaker does not work.
The machine operates only when
stationary, otherwise the red
warning light turns on.
The battery autonomy is low.
The drive system electronic board
malfunction LED is flashing.
For further information refer to the Service Manual, available at any Nilfisk Service Center.

SCRAPPING

Have the machine scrapped by a qualified scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
Law in force:
Batteries
Polyester dust filter
Main and side brooms
Plastic hoses and components
Electrical and electronic components (*)
(*)
Refer to the nearest Nilfisk Center especially when scrapping electrical and electronic components.
24
INSTRUCTIONS FOR USE
Possible cause
The battery connector is disconnected.
The F1 fuse in the box is open.
The battery charger cable is connected to the
electrical mains.
The parking brake is engaged.
When starting the machine with the ignition key, the
drive pedal is pressed, or the operator is not yet on
the driver's seat.
The FT fuse is open.
The FA circuit breaker is deactivated.
The main broom is not lowered.
The FB circuit breaker is deactivated.
The vacuum system is turned off.
The F4 fuse in the box is open.
The dust filter is clogged.
The hopper is full.
The skirts are not properly adjusted or are worn.
The brooms are not properly adjusted.
The F2 fuse in the box is open.
The batteries are discharged.
The batteries are dead.
The battery capacity is low.
The drive system is malfunctioning.
SR 1101 B - 1464015000
Remedy
Connect the battery connector.
Replace the fuse.
Disconnect the battery charger cable from the
electrical mains.
Disengage the parking brake.
Start the machine with the ignition key, only after
being on the driver's seat and without pressing the
drive pedal.
Replace the fuse.
Reset the fuse by pressing the relevant switch.
Lower the main broom.
Reset the fuse by pressing the relevant switch.
Turn on the vacuum system with the switch.
Replace the fuse.
Clean the dust filter by using the filter shaker or by
disassembling it.
Empty the hopper.
Adjust/replace the skirts.
Adjust the broom height.
Replace the fuse.
Charge the batteries.
If the trouble persists, replace the batteries.
Replace the batteries.
Buy batteries with higher capacity (see the Technical
Data paragraph).
To detect the failure, refer to the Service Manual (at
any Nilfisk Service Center).
04/2009

Advertenties

Inhoudsopgave
loading

Deze handleiding is ook geschikt voor:

9084310010

Inhoudsopgave