Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ENGINE AIR FILTERS CHECK/CLEANING (DIESEL and LPG version)
A dirty air filter limits the passage of air, thus reducing engine
performance. When working in particularly dusty areas, clean or
replace the filters more often than specified in the maintenance
programme.
CAUTION!
Running the engine without air filters, or with
damaged filters, can cause a faster engine
wearing.
1.
Drive the machine on a level ground and engage the
parking brake.
2.
Turn the ignition key (51) to "0".
3.
Open the engine compartment hood (19) and fasten it with
the support rod (47).
4.
(DIESEL Version). Lift and remove the left side panel (32).
(LPG version). Lift and remove the right side panel (31).
5.
Remove the wing nut (A, Fig. 27) and remove the cover
(B).
6.
Remove the wing nut (C) and disassemble the filter
element.
7.
Separate the paper filter (D) from the foam filter (E).
8.
Check both filters and replace them if necessary. Replace
the paper filter (D) when required (see the scheduled
maintenance table).
9.
To reuse the filters, clean them both by blowing
compressed air [at no more than 207 kPa (2.1 kgf/cm)]
inside the filter. Do not use a brush, otherwise the fibre will
be damaged.
10. Clean with a wet cloth the base and the cover (B) of the air
filter. Take care to prevent dirt entering the air duct (G).
11. Fit the foam filter (E) on the paper filter (D), then install
the assembled filter element. Ensure that the gasket (F) is
properly placed under the filter element. Screw down the
filter element wing nut (C).
12. Install the cover (B) and screw down the wing nut (A).
03/2016
INSTRUCTIONS FOR USE
DIESEL VERSION
A
B
LPG VERSION
1466472000 - SW5500, FLOORTEC R 985
G
C
D
E
A
B
C
D
E
G
Figure 27
ENGLISH
F
P100928
37
Advertenties
Hoofdstukken
Inhoudsopgave
