Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
AFTER USING THE MACHINE
After working, before leaving the machine, perform the following procedures.
–
Activate the filter shaker briefly by pressing the push-button (57).
–
Empty the hopper (12) (see the procedure in the previous paragraph).
–
Raise the brooms with the One-Touch push-button (52).
–
(Only for LPG version). Close the safety valve on the LPG tank (32), then let the engine run until all the fuel is expelled from
the hoses (then the engine is stopped).
–
Turn off the machine by turning the ignition key (51) to "0", then remove it.
–
Engage the parking brake.
NOTE
If the machine is left parked and inoperative, with the ignition key (51) in the "I" position, for more than 5 minutes, the
electrical system switches to a low power consumption mode (stand-by). To start work again, it is necessary to shut off
and restart the machine with the ignition key (51).
MACHINE LONG INACTIVITY
If the machine is not going to be used for more than 30 days, proceed as follows:
–
Perform the procedures shown in After Machine Use paragraph.
–
Check that the machine storage area is dry and clean.
–
(For Diesel version). Close the fuel tap (34).
–
(For LPG version). Close the LPG tank safety valve.
–
Disconnect the negative connector (-) of the batteries (46).
–
Handle the engine (42) as shown in the relevant Manual.
–
(For machines equipped with dust guard system). Empty the tank (23) and clean the water filter (see the procedure in
Maintenance chapter).
MAINTENANCE
The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defined by the person in charge of the maintenance.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by an authorised Service
Center.
CAUTION!
Each time the Service icon
scheduled maintenance.
This Manual describes only the easiest and most common maintenance procedures.
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted
at any Service Center.
WARNING!
To perform maintenance procedures, the machine must be off, the ignition key removed, and, if necessary, the
batteries must be disconnected.
Read carefully the instructions in the Safety chapter before performing any maintenance procedure.
SCHEDULED MAINTENANCE TABLE
Procedure
Engine oil level check
Battery fluid level check
Side and main broom height check
Engine air filter check
Hopper dust filter check and cleaning ("A" method)
03/2016
INSTRUCTIONS FOR USE
is shown on the display (71), contact an authorised Nilfisk Service Center for
Upon
delivery
(1)
1466472000 - SW5500, FLOORTEC R 985
Every
Every 10
Every 50
100
hours
hours
hours
(2)
(1)
(3)
ENGLISH
Every
Every
200
year
hours
23
Advertenties
Hoofdstukken
Inhoudsopgave
