Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
HDC155
7.1
Changing the door hinge
You can also change the hinge of the door, so that it opens to the left rather than the
right.
➤ Proceed as shown in the illustrations (fig. 2, page 3 to fig. 5, page 5).
7.2
Installing the refrigerator
Observe the following instructions when installing:
• Install the refrigerator so that the warm air produced can easily flow away (either
upwards or to the sides, fig. 6, page 5).
Key for fig. 6, page 5
No.
Explanation
1
Cold intake air
2
Hot waste air
3
Spacing above the refrigerator if there is not sufficient air to circulate
above or at the side.
• Leave the device to stand for at least four hours before you connect it to the
power supply so that the oil can flow back into the compressor.
• The installation dimensions can be found in fig. 7, page 6.
Proceed as follows to install the refrigerator:
➤ Proceed as shown in the illustrations (fig. 7, page 6 to fig. 8, page 7).
➤ Fix the cover panel to the refrigerator door as shown in the illustrations (fig. 9,
page 7 to fig. c, page 9).
7.3
Connecting the refrigerator to the power supply
A
NOTICE!
• To avoid voltage drops and loss of performance, keep the
connection cable as short as possible and not be interrupted.
Therefore avoid additional switches, plugs or power strips.
• Disconnect the cooling device and other electric consumers from
the battery before you connect the battery to a quick charging
device.
Overvoltage can damage the electronics of the device.
EN
Installing and connecting the refrigerator
19
Advertenties
Hoofdstukken
Inhoudsopgave
