Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Maintenance
➤ Have the gas system and connected flues inspected before initial operation and
then every two years by an authorised professional to ensure they comply with
national safety requirements (in Europe, this is EN 1949).
➤ Clean the gas burner after prolonged exposure to gas, at least once a year (chap-
ter "Cleaning the gas burner" on page 36). When using autogas (tank or refillable
cylinders), the service interval is reduced to twice or four times a year, depending
on the level of contamination. Contamination in the gas burner becomes notice-
able with poor ignition process or deflagrations.
➤ Keep a record of any maintenance performed in the vehicle.
9.1
Cleaning the gas burner
!
WARNING!
• Close the gas valve to the refrigerator before cleaning the gas
burner.
• Allow the burner to cool down before cleaning it.
• Do not modify the gas equipment. The gas burner can be cleaned
without removing the gas equipment.
I
NOTE
fig. l, page 13 Up to fig. n, page 14:
The RMD 85xx series can be equipped with a standard unit (B) or a high-
performance unit (A).
➤ Remove the ventilation grille (fig. j, page 13).
➤ Only with high-performance unit:
Remove the condensation container (fig. l, page 13, A).
➤ Only with high-performance unit:
Loosen the screw on the gas burner cover (fig. l, page 13, A).
➤ Press the catch below the burner cover inwards, and pull off the burner cover
(fig. l, page 13, A or B).
➤ Clean the burner pipe of coarse impurities using a suitable cleaning brush with
soft bristles (fig. m, page 14, A or B).
➤ Blow out the burner pipe with compressed air through the slots in the burner
pipe (fig. n, page 14, A or B).
➤ Attach the burner cover.
✓ The burner cover is fixed in place when it audibly clicks into place.
36
RMD8xxx
EN
Advertenties
Hoofdstukken
Inhoudsopgave
