Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
MC302, MC502
•
Make sure that the refrigerator door is able to open at least 100°. Otherwise the
drawers cannot be used.
➤ Check the dimensions of the device (fig. a, page 8 or fig. b, page 9).
➤ Place the device according to fig. 4, page 5 or fig. 5, page 5.
➤ Mount the device to the furniture by two screws through the fittings at the bottom
(fig. 6, page 6).
➤ Leave the device to stand for at least four hours before you connect it to the
power supply so that the refrigerant can flow back into the compressor.
6.4
Connecting the refrigerator to the power supply
A
NOTICE!
•
Connect the device to a separate circuit to prevent malfunctioning
due to problems with other electrical equipment. Never connect the
device to a single socket with other electrical equipment by means
of a multi-socket.
•
UK only: The refrigerator is supplied with a plug fitted with 3 A fuse.
In case this fuse has to be to changed, a 3 A ASTA approved
(BS 1362) fuse must be used.
➤ Connect the plug of the connection cable into the mains.
✓ The green power LED lights up (fig. 2 2, page 4).
➤ Press the
button.
✓ The display turns on.
For the first two seconds the display will not show temperature values; it shows
"--.-". Then the temperature read from the sensor is shown.
6.5
Mounting and removing the door handle
➤ Mount the handle as shown (fig. 7, page 6).
➤ Remove the handle as shown (fig. 8, page 7).
EN
Installing and connecting the refrigerator
17
Advertenties
Hoofdstukken
Inhoudsopgave
