Inhoudsopgave
Advertenties
1. Press the release button (D) to open the lid
(C).
2. Fill the dispenser (A) until the rinse aid reaches
the marking ''MAX''.
3. Remove the spilled rinse aid with an absorbent
cloth to prevent excessive foam formation.
4. Close the lid. Make sure that the release button
locks into position.
DAILY USE
1. Open the water tap.
2. Turn the knob until the programme marker is
aligned with the programme you want to set.
Set the correct programme for the type of load
and the degree of soil.
•
If the salt indicators is on, fill the salt
container.
•
If the rinse aid indicator is on, fill the rinse
aid dispenser.
3. Load the baskets.
4. Add the detergent.
5. Start the programme.
USING THE DETERGENT
A
B
CAUTION! Only use detergent
specifically designed for dishwashers.
1. Press the release button (B) to open the lid (C).
2. Put the detergent, in powder or tablets, in the
compartment (A).
3. If the programme has a prewash phase, put a
small quantity of detergent on the inner part of
the appliance door.
4. Close the lid. Make sure that the release button
locks into position.
12
30
20
C
You can turn the selector of the
released quantity (B) between position
1 (lowest quantity) and position 4 or 6
(highest quantity).
For information about the detergent
dosage, refer to the manufacturer's
instructions on the packaging of the
product. Usually, 20 - 25 ml of gel
detergent is adequate for washing a
load with normal soil.
Do not fill the compartment (A) with
more than 30 ml of gel detergent.
SETTING AND STARTING A PROGRAMME
Starting a programme
1. Open the water tap.
2. Close the appliance door.
3. Turn the knob until the programme marker is
aligned with the programme you want to set.
•
The on/off indicator is on.
•
The start indicator starts to flash.
4. Press
.
•
The programme starts.
•
The indicator of the washing phase is on.
•
The on/off indicator and start indicator are
on.
Starting a programme with delay start
1. Set a programme.
2. Press
to delay the start of the programme
by 3 hours.
The light related to the button is on.
3. Press
to start the countdown.
The light related to the button is on.
During the countdown, it is not possible to change
the programme.
When the countdown is complete, the programme
starts.
Cancelling the programme
Press and hold
until the light related to the
button starts to flash.
Advertenties
Inhoudsopgave
